Product Info

Introduction
The VSUB075 is an RF transceiver module. It interfaces with other
equipment using standard serial asynchronous communications protocol at a rate
between 9600 and 57600 baud. The transmitter has a peak output power of 140
milliwatts. It is designed to be incorporated into control devices developed by
Vantage Controls. The module operates under FCC approval in the 902-928
MHz ISM frequency band.
Integrating the VSUB075 Into Products
IMPORTANT: The VSUB075 radio has been certified by the FCC as a module
for integration into products without further certification being necessary (as per
FCC section 2.1091.) The following requirements must be satisfied in order to
comply with FCC regulations:
1) The system integrator must ensure that the external label provided with
this device is placed on the outside of the final product.
2) In order to comply with the FCC RF exposure requirements, the
VSUB075 may be used only with the antenna it was certified with (Vantage
Controls part number: VDA-0059), and a minimum separation distance of 20 cm
must be maintained from the antenna to any near by persons.
3) The VSUB075 radio requires a 8-12V DC 200mA supply.
Wording for External Label
This device contains transmitter module:
FCC ID: PII-VSUB075
The enclosed device complies with Part 15 of the
FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference,
and (2) this device must accept any interference
received, including interference that may cause
undesired operation.
Interface Pins:
Pin # Description
1 Power
2 RX
3 Ground
4 TX
5 /Reset
PCB Footprint
The PCB footprint is located in the PADS user library under the name
“RFDAUGHTERBOARD”. A drawing is on the following page.