Install Manual

(Baud rate, parity, handshaking changed) the download will hang
when th
is new information is sent to the master. The same is true
if on-line changes are being made, any on-line changes to the Q-
RS232S that is being used to communicate with the system can
cause the communications with Qlink to hang. Most often the Q-
RS232S should be left unconfigured if is being used with Qlink.
Memory Allocation on the Master. Each RS232 station will use
1200 bytes of memory on the master controller.
FCC ID: PII-S232RF
This device complies with Part 15 of the FCC Rules. Operation is
subject to the follow
ing two conditions: (1) This device may not cause
harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
NOTE: This equipment has been tested and found to comply with th
e
limits for a Class B digital device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequen
cy energy and,
if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or
more of the following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different
from that
to which the receiver is connected.
-- Consult the dealer or an experienced radio/TV technician for
help.
Changes or modifications to this product not expressly approved by
Vantage Controls could void the user’s authority to operate this
product.