Specifications

FCC ID: PII-RDS2000

This device complies with Part 15 of the FCC Rules. Operation

is subject to the following two conditions: (1) This device may

not cause harmful interference, and (2) this device must accept

any interference received, including interference that may cause

undesired operation.

NOTE: This equipment has been tested and found to comply

with the limits for a Class B digital device, pursuant to Part 15 of

the FCC Rules. These limits are designed to provide reasonable

protection against harmful interference in a residential

installation. This equipment generates, uses and can radiate

radio frequency energy and, if not installed and used in

accordance with the instructions, may cause harmful

interference to radio communications. However, there is no

guarantee that interference will not occur in a particular

installation. If this equipment does cause harmful interference to

radio or television reception, which can be determined by

turning the equipment off and on, the user is encouraged to try

to correct the interference by one or more of the following

measures:

-- Reorient or relocate the receiving antenna.

-- Increase the separation between the equipment and receiver.

-- Connect the equipment into an outlet on a circuit different

from that to which the receiver is connected.

-- Consult the dealer or an experienced radio/TV technician

for help.

Changes or modifications to this product not expressly approved

by Vantage Controls could void the user’s authority to operate

this product.

Removing Metal Tabs

Removal of metal tabs does not derate the stations load. (See

Load Ratings and Types above.)

Diagnostic Information

If the faceplate is removed the Status LED can be seen in the

approximate middle of the station’s switch matrix. The Status

LED blinks evenly or flashes 2, 3, or 4 times followed by a pause

to indicate status information.

Off: The station is not powered. A line voltage connection has

not been made or the line feed breaker is off.

Even blink: Station is operating correctly and is configured.

Two blinks: Station should be reset. See Reset above.

Three blinks: Station is not added to the network. Verify that its

serial number has been programmed into the Main Controller

using Design Center or QLink and that the station is within 100

Feet of the Main Controller.

Four blinks: Dimmer problem. Please contact the factory.