Specifications

Diagnostic Information

A red Status LED is located on top of the device. The Status

LED blinks evenly or flashes 2, 3, or 4 times followed by a pause

to indicate status information.

Off: The station is not powered. A line voltage connection has

not been made or the line feed breaker is off.

One Even blink: Station is operating correctly and is configured.

Two blinks: Station should be reset. See Reset above.

Three blinks: Station is not added to the network. Verify that its

serial number has been programmed into the Main Controller

using QLink and that the station is within 100 Feet of the

RFE1000.

Four blinks: AccentPoint Relay II problem. Please contact the

factory.

FCC Compliance Information:

FCC ID: PII-AP2RL

IC: 3505A-AP2RL

The enclosed device complies with Part 15 of the FCC Rules.

Operation is subject to the following two conditions: (1) This

device may not cause harmful interference, and (2) this device

must accept any interference received, including interference

that may cause undesired operation.

NOTE: This equipment has been tested and found to comply

with the limits for a Class B digital device, pursuant to Part 15 of

the FCC Rules. These limits are designed to provide reasonable

protection against harmful interference in a residential

installation. This equipment generates uses and can radiate

radio frequency energy and, if not installed and used in

accordance with the instructions, may cause harmful interference

to radio communications. However, there is no guarantee that

interference will not occur in a particular installation. If this

equipment does cause harmful interference to radio or television

reception, which can be determined by turning the equipment off

and on, the user is encouraged to try to correct the interference

by one or more of the following measures:

-- Reorient or relocate the receiving antenna.

-- Increase the separation between the equipment and receiver.

-- Connect the equipment into an outlet on a circuit different from

that to which the receiver is connected.

-- Consult the dealer or an experienced radio/TV technician for

help.

Changes or modifications to this product not expressly approved

by Vantage Controls could void the user’s authority to operate

this product.