Specifications

ManualsBrandsVantage Controls ManualsElectronicsAP2 Series lighting control devices

default, unplug the device, press and hold both buttons in and

plug it in while holding the buttons down. After a reset the load

profile will be Default, the learn levels will be 100%, the load will

be off, and other settings will be at factory default.

Note: If the Station Load was changed to RELAY* this Process

will change it back to DIM. Make sure it is back on-line with the

Main Controller before testing button or relay load operation.

*CAUTION: The station is shipped in “DIMMING MODE”. To

change the default mode to RELAY change the Power Profile to

Relay in Software. The Relay Mode change will not take place

until the system is programmed and the RF station is on line. A

motor should not be connected to the AccentPoint Dimmer

station, instead use the AccentPoint Relay station.

Diagnostic Information

A red Status LED is located on top of the device. The Status

LED blinks evenly or flashes 2, 3, or 4 times followed by a pause

to indicate status information.

Off: The station is not powered. A line voltage connection has

not been made or the line feed breaker is off.

One Even blink: Station is operating correctly and is configured.

Two blinks: Station should be reset. See Reset above.

Three blinks: Station is not added to the network. Verify that its

serial number has been programmed into the Main Controller

and that the station is within 100 Feet of the RFE1000.

Four blinks: Lamp Dimmer problem. Please contact the factory.

FCC Compliance Information:

FCC ID: PII-AP2RL

IC: 3505A-AP2RL

The enclosed device complies with Part 15 of the FCC Rules.

Operation is subject to the following two conditions: (1) This

device may not cause harmful interference, and (2) this device

must accept any interference received, including interference

that may cause undesired operation.

NOTE: This equipment has been tested and found to comply

with the limits for a Class B digital device, pursuant to Part 15 of

the FCC Rules. These limits are designed to provide reasonable

protection against harmful interference in a residential

installation. This equipment generates uses and can radiate

radio frequency energy and, if not installed and used in

accordance with the instructions, may cause harmful interference

to radio communications. However, there is no guarantee that

interference will not occur in a particular installation. If this

equipment does cause harmful interference to radio or television

reception, which can be determined by turning the equipment off

and on, the user is encouraged to try to correct the interference

by one or more of the following measures:

-- Reorient or relocate the receiving antenna.

-- Increase the separation between the equipment and receiver.

-- Connect the equipment into an outlet on a circuit different from

that to which the receiver is connected.

-- Consult the dealer or an experienced radio/TV technician for

help.

Changes or modifications to this product not expressly approved

by Vantage Controls could void the user’s authority to operate

this product.