User's Manual

Introduction
The ETII RF is an RF Control Board Module that contains a microcontroller and a RF
transceiver chip. It is designed to be incorporated into control devices developed by Vantage
Controls. The module operates under FCC approval in the 902-928 MHz ISM frequency band.
The module is limited to OEM installations only.
The module is limited to installation in mobile or fixed applications.
Integrating the ETII RF module into Products
The OEM is responsible that the end user has no manual or instructions to remove or install the
module.
IMPORTANT: The ETII RF radio has been certified by the FCC as a module for integration into
products without further certification being necessary (as per FCC section 2.1091.) The following
requirements must be satisfied in order to comply with FCC regulations:
1) The OEM/Integrator must ensure that final produce has a label, as shown below, placed
on the outside of the device.
2) The ETII RF module may only be used with the antenna that has been tested and
certified.
IMPORTANT: Separate approval is required for all other operating configurations, including portable
configurations with respect to Part 2.1093 and different antenna configurations.
IMPORTANT: Final products must be tested to comply with unintentional radiators (FCC section
15.107 & 15.109) before the OEM can declare compliance of their final product to Part 15 of the FCC
Rules. Testing for compliance must be performed with the module installed in the end-product.
We hereby acknowledge our responsibility to provide guidance to the host manufacturer in the event
that they require assistance for ensuring compliance with the Part 15 Subpart B requirements.