Owner`s manual

TSR-1 Remote Control
TruSine 4.5 kW Inverter Page 15 Owner’s Manual
↑ XXX º C ↓ battery temperature sensor is installed
GENERAL INFORMATION Menu:
Press right control buttons to scroll up. Press left control buttons to scroll down.
50 ↑ INVERTER SW (↓)
(↑) REV. 1.13 ↓
51 (↑)Model: (↓)
(↑) TSC24-4500(D) (↓)
52 (↑) TSR-2 (↓)
(↑) A88769-A (↓)
53 (↑)VANNER POWER GRP(↓)
(↑)4282 REYNOLDS DR (↓)
54 (↑)HILLIARD, OHIO (↓)
(↑)43026-1297, USA (↓)
55 (↑)PH: 614-771-2718 (↓)
(↑)FAX: [phone] (↓)
56 (↑)http:// (↓)
(↑)www.vanner.com (↓)
57 (↑)mail to:pwrsales (↓)
(↑)@vanner.com (↓)
ADVANCED CONTROL Menus:
60 Password Use control buttons to enter password: If correct go to
XXXX upper left, lower right, lower left, upper right. Step 61 if not
Go to Step 6
61 ADVANCED CONTROL Selects ADVANCED CONTROL submenu Go to Step 70
62 COMMUNICATIONS Selects the COMMUNICATIONS submenu Go to Step 90
ADVANCED CONTROL Menu:
70 ↑ InverterOutput ↓ Adjusts inverter AC output voltage setpoint Go to Step 71
+ XXX VAC - and the ±10% range for Aux AC input voltage
71 ↑ LowBatt Warn ↓ Adjusts inverter Low Battery Warning Go to Step 72
+ XX.XX VDC - DC Volts setpoint
72 ↑ LowBatt ShutDn ↓ Adjusts inverter Low Battery Shutdown Go to Step 73
+ XX.XX VDC - DC Volts setpoint
73 ↑ HighBat ShutDn ↓ Adjusts inverter High Battery Shutdown Go to Step 74
+ XX.XX VDC - DC Volts setpoint
74 ↑ BulkChrg Volts ↓ Adjusts Bulk Charge DC Volts setpoint Go to Step 75
+ XX.XX VDC -
75 ↑ Bulk Chrg Amps ↓ Adjusts Bulk Charge DC Amps setpoint Go to Step 76