Installation manual

RE Owners Manual
5-14
Copyright

2001 Phone: [phone] RE-4500
Vanner Inc. FAX: [phone] Installation Manual
4282 Reynolds Dr. www.vanner.com Rev 10d
Hilliard Ohio 43026 RE Owners_Manual_Rev10d D99988
INCORPORATED
INCORPORATEDINCORPORATED
INCORPORATED
Inverter Charger Control
This section describes the different methods for controlling
and configuring the RE-4500. There are two methods at this
time.
1. Inverter/Charger Controller
2. RE-ICC for Windows
The Inverter/Charger Controller is a handheld remote that
allows field display and configuration of parameters related to
the operation of the RE-4500. The ICC is connected to the
Inverter Serial Control Connector.
RE-ICC for Windows is a Windows based program that
supports a Windows type Graphical User Interface for
displaying, controlling, configuring, and upgrading software
relating to the operation of the RE-4500. Its’ primary purpose
is to assist an installer in the configuration and field setup of
the RE4500. The RE-ICC for Windows operation is not
covered in this document. For more information on RE-ICC
for Windows, please refer to the RE-ICC for Windows
Operations Manual.
Inverter/Charger Controller
This section describes the operation of the Inverter/Charger
Controller which is shown in Figure 5-1: Inverter/Charger
Controller. The RE-ICC is used to communicate commands
and to monitor the status of the RE-4500. It enables the user to
control the system from a number of menus that control
different aspects of the RE-4500’s operation.
Warning
The Factory Default Settings the unit is shipped with should only be
changed by a Vanner Certified Installer or by Authorized Factory
Personnel. There are no field adjustable Trip Points. All of these
Trip points are password protected to avoid incorrect entries.
Warning
Wrong settings can damage the unit, and lead to personal injury or
death, and voiding of the manufacturers warranty.