Installation manual

Component Identification
4-7
Copyright

2001 Phone: [phone] RE-4500
Vanner Inc. FAX: [phone] Installation Manual
4282 Reynolds Dr. www.vanner.com Rev 10d
Hilliard Ohio 43026 RE Owners_Manual_Rev10d D99988
INCORPORATED
INCORPORATEDINCORPORATED
INCORPORATED
(15) Battery Temperature Sensor Monitor Port
At this time, this is an option on 24 Volt systems only!
This RJ11 Port enables battery bank temperature monitoring
with the optional Vanner Battery Temperature Sensor (Vanner
Part Number RE-BTS1). This sensor is used for optimizing
battery charging efficiency, extending battery life, and battery
fault monitoring.
Warning
This connector is for the Battery Temperature Sensor Only!
Attaching any other device to this connector can result in loss of
life, damage to the system, and voiding of your manufacturers
warranty.
Check your terminations carefully!
(16) Relay A Contacts – Low Batt
These terminals are available to the user from the RE-4500 and
can be used for several programmable functions. These
functions are listed in Table 4-1: Relay Configurations for
Relay A. The Factory Setting for this set of contacts is for Low
Battery Alarm. These three Terminals are designated as
Normally Open, Common, and Normally Closed.
Function Configuration Comments
Low Battery Alarm Form C Factory Setting
(17) Relay B Contacts
These terminals are available to the user from the RE-4500 and
can be used for several programmable functions. These
functions are listed in Table 4-2: Relay Configurations for
Relay B. There is no assigned condition for this set of contacts
at this time. These three Terminals are designated as Normally
Open, Common, and Normally Closed.
Function Configuration Comments
Not Assigned Form C
Table 4-1: Relay Configurations for Relay A
Table 4-2: Relay Configurations for Relay B