Installation manual

Component Identification
4-3
Copyright

2001 Phone: [phone] RE-4500
Vanner Inc. FAX: [phone] Installation Manual
4282 Reynolds Dr. www.vanner.com Rev 10d
Hilliard Ohio 43026 RE Owners_Manual_Rev10d D99988
INCORPORATED
INCORPORATEDINCORPORATED
INCORPORATED
System
IN
V
E
R
T
E
R
C
H
A
R
G
E
R
T
E
M
P
E
R
A
T
U
R
E
G
E
N
E
R
A
T
O
R
B
A
T
T
E
R
Y
U
T
IL
IT
Y
ON
OFF
4
67
8910
5
(4) Inverter LED
Off The RE-4500 is not inverting, however, if all of the other front
panel indicators are also off, then the RE-4500 is OFF.
Green The RE-4500 is Inverting, Charging or Grid Interactive.
If blinking, it is Inverting and in “Load Demand.”
Orange The RE-4500 is Inverting and in “brownout” and/or is constantly
supplying its maximum current.
If the system is in “Charging” mode and this LED is orange, the
charger is supplying its maximum current.
Red The RE-4500 has shutdown due to a “brownout” Condition.
(5) ON/OFF Switch (and RESET Switch)
The ON/OFF Switch is a two-position switch used to turn the
inverter electronics ON and OFF. This ON/OFF switch can
also be used to RESET any faults that might be present.
These faults are displayed on the Indicator LEDs and in the
ALARM Menu of the optional Inverter. These faults will be
displayed until the Inverter is RESET by turning it “OFF” and
then back “ON”.
If the fault is serious enough, the inverter will automatically
shut itself OFF. Likewise, the inverter can be RESET by
turning the ON/OFF Switch “OFF”, and then back “ON”.
Figure 4-2: Inverter/Charger Front Panel Indicators