Specifications

Owners Manual
SILENT RUNNER INVERTER/CHARGER POWER SYSTEM
8
2 SAFETY INSTRUCTIONS
README
This manual contains important safety and operating instructions for the Vanner Incorporated Silent Runner Series
Power Inverter/Charger System. The SR-Series Inverter/Charger is designed to be compliant with UL 458, Power
Converters/Inverters and Power Converter/Inverter Systems for Land Vehicles.
SAVE THESE INSTRUCTIONS
WARNING This equipment employs components that tend to produce arcs and sparks. To prevent fire or
explosion, DO NOT install in confined areas or compartments that contain batteries or flammable
materials.
WARNING Risk of electrical shock. Use only the circuit breaker(s) specified in the installation and operating
instructions supplied with this inverter. Other types may fail to operate properly when connected to
this equipment.
CAUTION Read Owners Manual BEFORE wiring or powering up.
CAUTION DO NOT cover or obstruct ventilation openings. DO NOT mount in zero-clearance compartments.
Overheating may result which may diminish system capacity.
NOTICE The output of this device in not sinusoidal. The SR-SERIES inverter has a total harmonic distortion
of 34.6 percent and maximum single harmonic of 24 percent.
2.1 General Precautions
1 Do not expose the SR-Series Inverter to direct water spray or snow.
2 To reduce the risk of a fire hazard, do not cover or obstruct the ventilation openings.
3 Do not install this unit in a zero clearance compartment the result may be overheating or diminished
performance.
4 To avoid the risk of fire, electric shock, or injury to persons, do not use attachments, breakers, fuses, etc. not
recommended or sold by Vanner Incorperated.
5 Vanner recommends that all DC and AC electrical wiring be performed by a certified electrician or technician to
ensure compliance with all proper national and local wiring regulations.
6 To avoid a risk of fire and/or electric shock, always verify wiring connections are in good electrical condition. All
external conductors must use proper wire size to avoid dangerous overheating or diminished performance.
7 If the Vanner inverter system has been dropped or damaged in any way, do not operate until its operation has
been verified to be safe by a qualified technician.
8 To reduce the risk of electric shock always disconnect the AC and DC connections to the Vanner Inverter system
before attempting any maintenance. Simply turning the unit off does not prevent electric shock.
9 The SR-Series inverter system must be properly grounded in accordance with local and national codes and
ordinances before operation. For most installations the negative (ground) conductor should be bonded to the
grounding system at one and only one point in the system.
10 Do not disassemble the SR-Series Inverter/Charger; see the service section of this manual for instructions on
obtaining service for your Inverter/Charger. Attempting to service the unit yourself may result in a risk of
electrical shock or fire