Owner`s manual

Front Panel Wiring Identification
ITC-Series
Inverter Page 9 Owner’s Manual 8/07/03
Equalize button access
Through Access hole.
Overload
Overload
Low Battery
Bulk
Fault
Fault
INCORPORATED
Inverter
On/Off
Charger
On/Off
On/Off Switch for Inverter
On/Off Switch for Charger
Serial Communications
Connection
Configuration Switches
for Programming
Configuration Switches Access
Configuration Switches
Note: Power Must be
Cycled to read a new
DIP Switch value
F 3 Figure 1.4-2 ITC Control/Display Unit
F 4 Figure 1.4-3 ITC Control/Display Unit Component Identification
ITEM DESCRIPTION
1 Inverter Indicator
Light
Solid when on, flashes when enabled but not on
2 Inverter On/Off
Button
Enables/Disables Inverter Function
3 Charger Indicator
Light
Solid when on, flashes when enabled but not on
4 Charger On/Off
Button
Enables/Disables Charger Function
5 Overload Light Dual Purpose – Indicates if Inverter or Charger is Overloaded
6 Low Battery/Bulk
Light
Dual Purpose – Indicates Low Battery in Inverter Mode – In charger mode, if on indicates that
Charger is in Bulk Mode and if in Equalize, this light flashes.
7 Fault Light Dual Purpose – Indicates that a fault has occurred in the inverter or Charger – Could be a Over
Temperature shutdown, Low/High Battery Shutdown, Power Stage Fault, or Input AC fault
8 Equalize Button This is used to enable the equalization cycle on the battery during charging.
Overload
Overload
Low Battery
Bulk
Fault
Fault
INCORPORATED
Inverter
On/Off
Charger
On/Off
1
2
3
4
5
6
7
8