Installation manual

www.fmiproducts.com
113195-01K18
INSTALLATION
Continued
OPTIONAL WIRELESS HAND-HELD
REMOTE CONTROL ACCESSORIES
(HRC100 Series and HRC200 Series)
Installing Remote Receiver Unit
1. Disconnect switch wires from control valve.
2. Remove screws attaching switch plate.
3. Remove switch plate (see Figure 26).
Discard after removing.
4. Install remote receiver unit onto gas log
heater base using mounting clips.
5. Push clips firmly into place (see Fig-
ure 27).
6. Connect wires as shown in Figure 28.
Figure 26 - Switch Plate and Wiring
Harness
Screw
Switch
Plate
Wires
Remote Switch
Bracket
Ignitor
Figure 27 - Installing Remote Receiver
Figure 28 - Connecting Wires
Red Wire From
Receiver
Valve
White
Wire From
Receiver
Remote
Receiver
Mounting
Clips
INSTALLING 9-VOLT BATTERIES
Two 9-volt batteries (not included) are re-
quired to operate this heater with wireless
hand-held remote control set. Install one bat-
tery in receiver and one in hand-held remote
control unit.
Note: Only use alkaline batteries.
Installing 9-Volt Battery (Not Included) in
Receiver
1. Locate back of receiver under front burner
of heater.
2. Locate battery clip mounted on back of
receiver.
3. Slide a 9-volt battery through the clip.
4. Attach terminal wires to battery.
Installing 9-Volt Battery (Not Included) in
Hand-Held Remote Control Unit
1. Remove battery cover on back of remote
control unit.
2. Attach terminal wires to battery. Place
battery into battery housing.
3. Replace battery cover onto remote control
unit.
Figure 29 - Installing Battery in Remote
Receiver
Battery
Clip
9-Volt Battery
Terminal
Wires
Remote
Receiver
Figure 30 - Installing Battery in Hand-Held
Remote Control Unit
Battery
Cover
9-Volt Battery
Terminal
Wires
Remote
Control Unit
Battery
Housing