Specifications

046-08OP-001D S/N 046050010021 - UP

h. Pull the cable until the line is tight in order to seat wedge (13). Lift the lower block above the ground.

i. Raise the boom.

Hydraulic System Oil - Change

Refer to the specific tractor Operation and Maintenance Manual "Hydraulic System Oil - Change" for complete

requirements and procedures.

At operating temperature, the hydraulic tank is hot and under pressure. Hot oil and components can cause personal

injury. Do not allow hot oil or components to contact skin. Remove the filler cap only when the engine is stopped, and the

filler cap is cool enough to touch with your bare hand. Remove the filler cap slowly in order to relieve pressure.

NOTICE

Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and

repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or

disassembling and component containing fluids.

Dispose of all fluids according to local regulations and mandates.

Operate the machine in order to warm the oil.

Park the machine on level ground. Engage the parking brake and stop the engine.

Figure 43: Hydraulic tank filler cap

Remove the hydraulic tank filler cap (1) slowly in order to relieve any pressure.

1. Wash the filler strainer and the filler cap in a clean nonflammable solvent.

2. Remove oil drain plug (2).

3. Attach a hose to a 1 inch NPT pipe nipple. This 1 inch NPT pipe nipple should have a length of 100 mm (4 inch).

4. Install the pipe nipple into the drain plug opening.

5. Rotate the pipe nipple clockwise in order to open the internal drain valve. Allow the oil to drain into a suitable

container.

046-11-60-001A