Specifications

046-08OP-001D S/N 046050010021 - UP
37
Hook Load Line – Install
Do not operate or work on this equipment unless you have read and understand the instructions and warnings in the
Operation and maintenance Manual. Failure to follow the instructions or heed the warnings could result in injury or
death. Proper care is your responsibility.
Personal injury or death can result from worn wire rope cable. Worn or frayed cable could break causing injury. Check
the wire rope cable. If cable is worn or is frayed install new cable. Wear gloves when handling the wire rope cable.
NOTICE
Make sure that the construction of the wire rope is 6x25 IWRC XIPS (Independent Wire Rope Core, eXtra Improved Plow
Steel) USA MADE. Also, the established grade of the wire rope is the improved plow bolt (steel), 26670 kg (58 800 lb)
minimum breaking strength.
SPECIFICATIONS (WIRE ROPE)
Hook Load Line Cable
Boom Length
Diameter Length
6.1 m (20 ft)
19.05 mm
(0.75 inch)
50.3 m (165 ft)
7.3 m (24 ft)
19.05 mm
(0.75 inch)
57.3 m (188 ft)
Table 8: Hook load line wire rope specifications
1. Lower the boom to the horizontal position.
2. Remove the anchor for the wire rope from the drum for the hook. Remove the old wire rope.
3. Unroll the new wire rope from the spool.
Note: Weld the cable ends in order to prevent fraying.
NOTICE
Unroll all of the cable from the spool. Lay the wire rope on a flat surface. Never lift the wire rope off the spool in coils.
Figure 41: Installing hook load line, cable anchor assembly