Specifications

046-08OP-001D S/N 046050010021 - UP
31
Figure 32: Installing boom line, cable anchor assembly
4. Install the cable (1) into the small slot and through the larger slot in the drum for the boom.
a. Make sure that 2 to 4 threads of capscrew (2) are engaged into the cable anchor assembly (4). Start with the
capscrew and insert the cable anchor assembly into the longer slot as far as allowed.
b. Make sure that the lip of retainer (3) faces the top edge (5) of the small slot in order to hold the retainer in
place. Make a loop with the end of the wire rope and insert the end into the slot past the cable anchor assembly.
c. Pull the wire rope until the wire rope and anchor assembly are securely seated inside the slot. Tighten the
capscrew to a torque (6) of 44 ± 3N·m (32 ± 2 lb ft).
5. Wind one half of the wire rope on the drum (7.) Wind the wire rope evenly across the drum.
Figure 33: Installing boom line
(A) Wire rope from the winch. (B) Detail B