Specifications

046-08OP-001D S/N 046050010021 - UP
30
Boom Line – Install
Do not operate or work on this equipment unless you have read and understand the instructions and warnings in the
Operation and Maintenance Manual. Failure to follow the instructions or heed the warnings could result in injury or
death. Contact your dealer or Vanguard Equipment or visit our website at vanguardequip.com for replacement manuals.
Proper care is your responsibility.
Personal injury or death can result from worn wire rope cable. Worn or frayed cable could break causing injury. Check
the wire rope cable. If cable is worn or is frayed install new cable. Wear gloves when handling the wire rope cable.
Proper care is your responsibility.
NOTICE
Make sure that the construction of the wire rope is 6x25 IWRC XIPS (Independent Wire Rope Core, eXtra Improved Plow
Steel) USA MADE. Also, the established grade of the wire rope is the improved plow bolt (steel), 26670 kg (58 800 lb)
minimum breaking strength.
SPECIFICATIONS (WIRE ROPE)
Boom Line Cable
Boom Length
Diameter of
Cable
Length of
Cable
6.1 m (20 ft)
19.05 mm
(0.75 inch)
40.2 m
(132 ft)
7.3 m (24 ft)
19.05 mm
(0.75 inch)
45.7 m
(150 ft)
Table 7: Boom line wire rope specifications
1. Lower the boom to the ground and support the boom.
Note: The loaded force in the winch drum must be neutralized before removing the wire rope from a loaded drum.
2. Remove the anchor for the wire rope from the drum for the boom. Remove the old wire rope.
3. Unroll the new wire rope from the spool.
Note: Weld the cable ends in order to prevent fraying.
NOTICE
Unroll all of the cable from the spool. Lay the wire rope on a flat surface. Never lift the wire rope off the spool in coils.