Specifications

046-08OP-001D S/N 046050010021 - UP

Transportation Information

Shipping the Machine

Investigate the travel route for overpass clearances. Make sure that there is adequate clearance for the machine that is being

transported.

Remove ice, snow, or other slippery material from the loading dock and from the truck bed before loading. Removing ice,

snow, or other slippery material will prevent slippage while you load the machine. Removing ice, snow, or other slippery

material will prevent the machine form slipping in transit.

NOTICE

Obey all state and local laws governing the weight, width, and length of a load. Observe all regulations governing wide

loads.

1. Place blocks under the trailer wheels or under the rail car wheels before loading, as shown.

2. Move the transmission control lever to the NEUTRAL position.

3. Engage the parking brake switch.

4. Stop the engine.

5. Turn the start switch key to the OFF position. Remove the key and lock the parking brake switch.

6. Turn the battery disconnect switch to the OFF position. Remove the key.

7. Attach any vandalism protection and lock the access covers.

8. Install the tie-downs at several locations and chock the tracks in the front and in the rear.

9. Cover the opening for the engine exhaust in order to prevent rotation of the turbocharger that is caused by the force

of the wind.

NOTICE

Rotation of the turbocharger without engine operation can result in damage to the turbocharger. Cover the exhaust opening

or secure the rain cap in order to prevent the turbocharger from wind milling in transit. Refer to the tractor operation and

maintenance manual for additional requirements and information.

Removal of the Boom

Figure 25: Removal of the boom

035-05-05-020B