Specifications

046-08OP-001D S/N 046050010021 - UP
17
Daily Inspection
Figure 19: Daily inspection walk around
For maximum service life of the machine, perform a daily walk-around inspection.
Note: Watch closely for leaks. If leaking is observed, find the source of the leak and correct the leak. If leaking is suspected
or leaking is observed, check the fluid levels more frequently.
Inspect the machine for the following items:
• Inspect the hydraulic system for leaks. Repair any hydraulic system leaks. Inspect the hoses, the seals, and the flanges.
• Inspect the winch final drive for leaks. Repair any final drive leaks.
• Inspect covers and the guards for damage, for loose bolts, and for missing bolts.
• Inspect the condition of the steps and of the handholds. Inspect the steps and the handholds for cleanliness. If necessary,
repair the steps or clean the steps.
• Inspect the operator compartment for cleanliness. Remove any trash buildup and any dirt buildup.
• Inspect mirrors and make sure they are in good condition and replace if broken.
Note: Refer to the tractor operation manual for detailed information on the specific daily inspection of the tractor unit.
NOTICE
Accumulatedgreaseandoilonamachineisafirehazard.

Removedebriswithsteamcleaningorhighpressurewater,atthespecifiedintervalintheMaintenanceIntervalSchedule
oreachtimeanysignificantquantityofoilisspilledonthemachine.
Daily Checks
After you inspect the machine, perform the daily maintenance that is listed in the maintenance interval schedule. Perform the
daily maintenance before you mount the machine in order to operate the machine.
Refer to Operation and Maintenance Manual, "Maintenance Interval Schedule" for the correct procedures for the following
checks:
• "Boom Pivot Pins - Lubricate"
• "Cooling System Coolant Level - Check"
• "Counterweight Cylinder Bearings - Lubricate"
035-05-05-019B