Specifications

046-08OP-001D S/N 046050010021 - UP
10
Operation
Machine Operating Temperature Range
The standard pipelayer component configuration is intended for use within an ambient temperature range of -40 °C (-40 °F)
to 50 °C (122 °F). Special configurations for different ambient temperatures may be available. Consult your dealer for
additional information. Refer to the specific tractor Operation and Maintenance manual for standard tractor capabilities.
Machine Operation
Only operate the machine while you are in a seat. The seat belt must be fastened while you operate the machine. Only
operate the controls while the engine is running.
Before you move the machine, make sure that no one will be endangered.
Check for proper operation of all controls and protective devices while you operate the machine slowly in an open area. Do
not allow riders on the machine unless the machine has the following equipment:
• additional seat
• additional seat belt
Report any needed repairs that were noted during operation.
Do not go close to the edge of a cliff, an excavation, or an overhang.
If the machine begins to sideslip, turn the machine downhill.
Be careful to avoid any condition which could cause the machine to tip. The machine can tip when you work on hills, banks
and slopes. Also, the machine can tip when you cross ditches, ridges or other obstacles.
Whenever it is possible, operate the machine up the slopes and down the slopes. Avoid operating the machine across the
slope, when possible.
Keep the machine under control. Do not overload the machine beyond capacity.
Be sure that the towing eyes and towing devices are adequate.
Towing eyes and towing devices should only be used to recover the machine.
Connect trailing equipment to a drawbar or to a hitch only.
When you maneuver the machine to connect equipment, be sure that there are no personnel between the machine and the
trailing equipment. Block the hitch of the trailing equipment in order to align the equipment with the drawbar.
Never straddle a wire cable or allow other personnel to straddle a wire cable.
Know the maximum dimensions of your machine.
Lifting Capacities
Maintain control of the machine. Do not overload the machine beyond the machine capacity. Ensure that the correct load
chart is referenced. Loads must be within the capabilities of the machine. Lifting capacity decreases as the load is moved
further from the machine.
Use lifting slings that are approved and use lifting slings that are load tested. Also, all wire ropes or chains must be properly
maintained. The wire ropes and chains must meet local regulations. You must know the load carrying capacity of these
devices and you must know the correct use of these devices.
Wire rope limitations, soil conditions, and slope of terrain reduce actual capacity. All lifts must be made with the load line
vertical, and the boom centerline directed toward the load.
To prevent cable from slipping off the drum, a minimum of five full-wraps of cable must remain on the winch drum at
maximum working extension of the hook or boom.