Installation manual

111285-01A
For more information, visit www.desatech.com
For more information, visit www.desatech.com
8
Surround Side
5/16" Screws
Phillips
Screws
Figure 6 - Attaching Left Surround Side Panel
3. Align holes in left surround side panel with screen mounting
screw holes. Replace 5/16" screen mounting shoulder screws
removed in step 1 (see Figure 6). Do not tighten. Install Phillips
screws in bottom (see Figure 6). Repeat for right side.
4. Using Phillips screwdriver, remove four screws attaching brass
louver. Install one Phillips head screw (included with kit) in
each side (see Figure 7).
5. Align top panel screw holes. Install four Phillips screws, do
not tighten.
6. For model GS43, align six screw holes in side panels with holes
in top panel (see Figure 9). For model GS38, align two screw
holes in side panels with holes in top panel (see Figure 9). Insert
and tighten screws.
7. Carefully inspect fireplace surround assembly. Make sure each part
fits properly. Firmly tighten all screws installed during assembly.
CAUTION: Do not overtighten. Metal can bend,
warp, or break under excessive strain.
8. Remove three pieces of brass trim from packaging.
9. Locate four brass screws, two adjusting plates with set screws,
and two shims in the brass hardware packet.
10. Align shim under adjusting plate as shown in Figure 10, page 9.
11. Slide one end of adjusting plate/shim in slot of top brass trim
(see Figure 10, page 9).
12. Slide other end of adjusting plate/shim in slot on mitered edge
of side brass trim (see Figure 10, page 9).
13. While firmly holding edges of brass trim together, tighten both
set screws on the adjusting plate with slotted screwdriver.
14. Repeat for other side.
15. Line up holes in brass trim with holes on side panels of fire-
place surround assembly. Attach with brass-plated screws.
16. Move fireplace insert and surround assembly to masonry fire-
place opening. Make sure fireplace insert and surround assem-
bly fit properly.
Figure 7 - Remove Brass Louver
Brass
Louver
Phillips Screws
Top Surround
Panel
Louver Screw Holes
Figure 8 - Attaching Top Surround Panel
Phillips
Screws (4)
INSTALLATION
Continued
Figure 9 - Attaching Side Panels to Top Panel (GS43 Pictured)
Top Panel
Side Panel
AIR FOR COMBUSTION AND VENTILATION
Installing Surround Kit (GS38 or GS43) (Cont.)