Installation manual

111285-01A
For more information, visit www.desatech.com
For more information, visit www.desatech.com
15
15
INSTALLATION
Continued
Figure 27 - Switch Plate and Wiring Harness
Screw
Switch
Plate
Wires
Figure 28 - Installing Remote Receiver
Figure 29 - Connecting Wires
Red Wire
From
Receiver
Valve
White Wire
From
Receiver
Remote Receiver
Mounting
Clips
Remote Switch
Bracket
Ignitor
INSTALLING 9-VOLT BATTERIES
Two 9-volt batteries (not included) are required to operate this
heater with the wireless hand-held remote control set. Install one
battery in the receiver and one in the hand-held remote control unit.
Note: Only use alkaline batteries.
Figure 30 - Installing Battery in Remote Receiver
Battery Clip
9-Volt
Battery
Terminal
Wires
Remote
Receiver
Installing 9-Volt Battery (Not Included) in Hand-
Held Remote Control Unit
1. Remove battery cover on back of remote control unit.
2. Attach terminal wires to the battery. Place battery into the bat-
tery housing.
3. Replace battery cover onto remote control unit.
Figure 31 - Installing Battery in Hand-Held Remote Control Unit
(GHRC Series)
Battery
Cover
9-Volt
Battery
Terminal
Wires
Remote
Control Unit
Battery
Housing
Figure 32 - Installing Battery in Hand-Held Remote Control Unit
(GHRCTA Series)
9-Volt
Battery
INSTALLATION
Optional Wireless Hand-Held Remote Control Accessories (GHRC and GHRCTA)
Installing 9-volt Batteries
Remote
Control
Unit
Battery
Cover
Terminal
Wires
OPTIONAL WIRELESS HAND-HELD REMOTE
CONTROL ACCESSORIES
(GHRC and GHRCTA)
Installing Remote Receiver Unit
1. Disconnect switch wires from the control valve.
2. Remove screws attaching switch plate.
3. Remove switch plate (see Figure 27). Discard after removing.
4. Install remote receiver unit onto gas log heater base using
mounting clips.
5. Push clips firmly into place (see Figure 28).
6. Connect wires as shown in Figure 29.
Installing 9-Volt Battery (Not Included) in Receiver
1. Locate back of receiver under front burner of heater.
2. Locate the battery clip mounted on the back of the receiver.
3. Slide a 9-volt battery through the clip.
4. Attach the terminal wires to the battery.