Installation manual
www.desatech.com
901267-01E14
TROUBLESHOOTING
Note: All troubleshooting items are listed in order of operation.
POSSIBLE CAUSE
1. Poor fuel quality
2. Fireplace venting system
not drafting properly
3. Excessive ame impinge-
ment or blockage
4. Improper fuel/air mixture
5. Excessive gas supply/
pressure
1. Passage of air/gas across
irregular surfaces
1. Incorrect gas supply or
pressure
2. Blocked burner orice or
burner manifold ports
3. Improper burner orifice
size
1. Ignitor electrode not con-
nected to ignitor cable
2. Ignitor cable pinched or
wet
3. Bad ground on piezo
ignitor
4. Broken ignitor cable
5. Bad piezo ignitor
6. Ignitor electrode broken
7. Ignitor electrode posi-
tioned wrong
OBSERVED PROBLEM
Log set is smoking/sooting
excessively
(Note: It is natural and un-
avoidable for vented gas log
sets to produce moderate
levels of carbon (soot) where
ames contact the logs. This
is especially true with pro-
pane/LP gas.)
Burner is excessively noisy
(Note: The movement and
combustion of gas will cre-
ate low, unavoidable levels
of noise.)
Burner ame is too low or
too high
When ignitor button is pressed,
there is no spark at pilot
(GA9050A-1 Only)
REMEDY
1. Contact local natural or
propane/LP gas company
2. Adjust damper wide open
and/or have replace and
venting professionally
cleaned and checked
3. Separate the logs to allow
more ame passage
4. Remove any foreign items
from the ame pattern and/
or check for proper orice
sizing
5. Preheat flue in very cold
weather
1. Relieve any tight bends or
kinks in gas supply line
1. Check for proper gas sup-
ply pressure
2. Free burner orifice and
manifold ports of any burrs,
paint or other blockage
3. Verify proper burner ori-
fice sizing (see Figure 2,
page 5)
1. Reconnect ignitor cable
2. Free ignitor cable if pinched
by any metal or tubing.
Keep ignitor cable dry
3. Scrape away paint on brack-
et for better contact with
ground on piezo ignitor
4. Replace ignitor cable
5. Replace piezo ignitor
6. Replace electrode
7. Reposition electrode