Installation manual

www.desatech.com
901267-01E12
Ignitor
Control Knob Pilot
FROM "PILOT" POSITION
SLIGHT PUSH TO
TURN OFF
PULL PUSH
TO LIGHT
ON
ON
FROM "PILOT" POSITION
SLIGHT PUSH TO
TURN OFF
PULL PUSH
TO LIGHT
FROM "PILOT" POSITION
SLIGHT PUSH TO
TURN OFF
PULL PUSH
TO LIGHT
ON OFF
On
Off
OFF
OFF
Figure 18 - Ignitor and Control Knob
OPERATION

Turn gas shutoff valve clockwise to
the OFF position.
FOR YOUR SAFETY
READ BEFORE LIGHTING
  

WARNING: If you do not fol-
low these instructions exactly,
     
-

-



WHAT TO DO IF YOU SMELL GAS
 
 

 
     

 

LIGHTING
INSTRUCTIONS
1. STOP! Read the safety information,
above.
2. Turn the gas shutoff valve to OFF.
3. Wait ve (5) minutes to clear out any
gas. If you then smell gas STOP! Follow
the safety information above. If you don‘t
smell gas, go on to the next step.
4. Lay a lit match on top of pan material about
2" from end of supply side of pan.
5. Slowly turn gas shutoff valve ON until
burner ignites. If burner does not ignite
within 10 seconds with match burning,
turn shutoff valve OFF and repeat steps
1 through 4 again.
GAS SHUTOFF
VALVE OPERATION

Adjust the ame ON/OFF by turning the gas
shutoff valve counterclockwise to open
or clockwise to close, as necessary.
CURING
LOGS
During the 2-3 hour appliance break-in period,
you may detect an odor from the appliance
as the various paints and compounds used in
the manufacturing of this log set cure. This is
a normal and temporary situation that is not
cause for alarm. However, you may want to
provide extra ventilation to the room during
this time.
To ensure proper curing of the logs:
• Ignite a 2" flame and maintain it for 1
hour.
• Burn the logs in consecutive 1 hour periods
raising the ame an additional 2" to full
ame height for a total of three hours.
OPERATING
INSTRUCTIONS

Note: Operation instructions for GA9150A
Remote Ready ON/OFF Safety Valve/Pilot
Kit will be included with the kit.
1. STOP! Read the safety information, col-
umn one.
2. Make sure equipment shutoff valve is fully
open.
3. Press in and turn control knob clockwise
to the OFF position.
4. Wait ve (5) minutes to clear out any gas.
Then smell for gas around log set and
near oor. If you smell gas, STOP! See
safety information, page 3. If you don’t
smell gas, go to the next step.
5. Turn control knob counterclockwise
to the PILOT position and press
in. Keep control knob pressed in for ve
(5) seconds.