Manual

REV 1 CT-7000 S3 USER’S MANUAL
118
When performing an OPEN-CLOSE
test, the breaker opens but will not
close.
• Delay between OPEN to CLOSE is probably too short. Increase the
delay time.
No data or erratic reading on travel
transducer.
• Bad transducer. Perform a transducer diagnostic test using the
instructions in section 4.2.
• Transducer slider is not secured to timing rod.
• Transducer is not secured properly.
No activity on “V2” or “V3” voltage
input channel.
• The “V2” and “V3” voltage sensing input channels require a
voltage change greater than 30V.
How do I turn on automatic printing
of test reports?
• Please see section 3.2.3.