Installation manual

5-24 Modifying Your Vanguard 7300
Removing and Replacing the T1/E1/PRI Card and Rear Transition Module
Removing and Replacing the T1/E1/PRI Card
Introduction This section explains how to remove and reinstall the T1/E1/PRI Card.
Note
Be sure to review all applicable warnings and cautions in the “General Card
Replacement Guidelines” section on page 5-2 before you begin.
Removing the
T1/E1/PRI Card
Use the steps in this table to remove the T1/E1/PRI Card from the
Vanguard 7300
enclosure:
Installing the
T1/E1/PRI Card
Use the steps in this table to install the T1/E1
/PRI Card into the Vanguard 7300
enclosure:
Step Action
1 Loosen the captive screws from the front of the T1/E1/PRI Card.
2 Eject the card by
pressing the two red ejector locks and then pressing the
card’s ejector levers outward at the
same time.
3 Pull the card from the enclosure and place it on a clea
n, grounded, and
static-free surface.
Caution
Avoid touching areas of integrated circuitry to prevent static discharge
damage.
Step Action
1 Open the ejector levers on the T1/E1/PRI card.
2 Align the card with the card rails on the chassis.
3 Carefully insert the card in the rails and slide it in until you feel
resistance.
4 Simultaneously press the ejector levers inward until they lock.
5 T
ighten the captive screws.