Installation manual

3-32 Vanguard 7300 Installation
Cabling Procedures
Carrier Expansion Card
Introduction Connectors on the front of the Carrier expansion card (Figure 3-24) are PMC slot
Ethernet ports of any installed Dual 10/100BaseT Ethernet PMCs.
Figu
re 3-24. Carrier Expansion Card Connectors
Cabling the 10/
10
0BaseT Etherne
t
Mezzanine Card
(PMC)
The 10/100BaseT Ethernet PMC can be installed on either the CPU card or on the
Carrier Expansion Card. For both cards, the two ports on the PMC are cabled at the
Vanguard 7300 front panel. Figure 3-24.
Note
Software configuration supports a maximum of five configured Ethernet ports
on a Vanguard 7300.
There are two RJ45 connectors on each Ethernet PMC, as shown in Figure 3-25.
Pinouts for the Ethernet PMCs RJ45 connectors are detailed in Appe
ndix B,
Vanguard 7300 Cable Connectors and Pinouts.
Figure 3-25. 10/100BaseT Ethernet PMC Connectors
Slot 1
Slot 2
ACT 100bT LINK