Installation manual

Part No. T0249-01, Rev A
April, 2002
6.0 Point Release 01B Software Capabilities Page 6 of 55
7300 Series Software Configuration Limits
Introduction This section describes the software configuration limits for the Vanguard 7300.
Configuration
Limits
This table lists the software configuration limits for:
• Physical Ports (physical port counts are set by software,
not the actual number of physical ports)
•FrameRelay
• Sessions
• Network Services
• LAN - (IP specific)
•Voice
• SNA/IBM Support
7300 Series Software Configuration Maximum
Limits 6.0
Physical Port
Physical ports 88
Ethernet ports per node (performance limited at 100MB speed per port)
5
Total LAN ports (Ethernet) per node (not bridge port support count) 5
Devices supported per Ethernet segment (Relevant to Bridge
operation)
255
High speed (V.35) serial links per node 56
PRI ports (data only) per node 84
T1/E1/PRI voice only ports per node 14
T3/E3 ATM ports per node 2
Voice circuits per voice server card 60
Number voice calls per node (Number shown is E1 max.) 420
Number voice calls per node (Number shown is T1 max.) 336
Frame Relay
Number of DLCIs per FR Port 820
Number of PVCs per FR Annex-G station 128
Number of SVCs per FR Annex-G station 512
Number of voice SVC per Annex-G station 15
Number of DLCIs per node 8,000
Session
Number of LCON 2,000
Number of Virtual Ports (FR, X25, PPP, Voice) 2,000