Installation manual

Part No. T0249-01, Rev A
April, 2002
Software Improvements Page 22 of 55
The TCP Module is not Forwarding a Message with the
FIN Bit Set - All Products
When placing a call between an H.323 port configured for G.723 (5.3kb, 5.3kb,
6.3kb, or 6.3kb) and another H.323 port that is configured for G.729A (8gkb, 8gkb3,
8gkb4, 8gkb5) the call should be cleared because H.323 doesn't support dynamic
coder. The call is not being cleared; it is established but there is no audio.
(DRCaa22073)
This is fixed.
Vanguard 7300 Series Transparent Bridge Does Not Work Properly
When more than one ethernet port is attached to the same ethernet, the transparent
bridging function might not work correctly. Other functionality such as IP routing
and LLC Conversion are not affected. (DRFaa17275)
This is fixed.
Vanguard 7300 Adding CBR Stations Requires a Node Boot
When adding a new station to an AAM port where the new station is configured for
Traffic Service Category is equal to CBR, a node boot is required for the
configuration to take effect. A node boot is also required when a station is changed
from UBR type to CBR type. (DRFaa16960)
This is fixed.
Vanguard 7300 Series - Alternate Gatekeeper
Due to network convergence times, if a node is configured with both a primary and
alternate gatekeeper address, the node may register with the alternate gatekeeper
after the boot up sequence. This is caused because the node attempts three times to
register with the primary gatekeeper. If network connectivity cannot be established
within the time frame of the first three attempts to the primary gatekeeper, the node
switches and registers to the alternate gatekeeper. (DRFaa18121)
This is fixed.
Codex Encapsulation Problem
Lower performance when running the default of Codex encapsulation. New default
is RFC1294. (DRFaa18369)
This is fixed.
Node Boot Command - All Products
During periods of high utilization the node boot process is not given a time slice to
operate. (DRCaa22729)
This is fixed.
Vanguard 7300 Series - Repeating pages during a Telnet session
When scrolling through multiple screens over a Telnet session, the same page
repeatedly is sent. (DRCaa22388)
This is fixed.