Installation manual

Part No. T0249-01, Rev A
April, 2002
Software Improvements Page 21 of 55
IP Routing Tables RIP Entries - All Products
RIP entries are not removed from the routing tables when RIP is disabled and IP
parameters are booted. (INDaa01337)
This is fixed.
NAT and LCON Boot - All Products
When a Vanguard is running Network Address Translation (NAT), NAT does not
learn the IP address after a NAT table boot if the LCON is already in the active state.
(INDaa00803)
This is fixed.
Vanguard 7300, 6455 - IP Protocol Standards (China)
IP Protocol must meet certain standards. (DRFaa13830)
This is fixed.
OSPF Interface and Area Parameters Node Crash - All Products
A node crash occurs after deleting all the OSPF interface and area parameters and
booting the OSPF menu. (INDaa00869)
This is fixed.
Vanguard 7300, 6400 Series - Over-Length Voice Switch Table-Pre-Post-
Fix Digits Parameter Causes Node Crashes
The help text screen for the Voice Switch Table-Pre-Post-Fix Digits parameter
indicates that you cannot configure more than 20 characters. However, during first
time configuration you can save more than 20 digits although a notice appears
informing you that "no more than 20 characters are allowed". This notice is
disregarded and the character string is saved. On subsequent configurations of this
parameter the notice does not appear and the 20+ character string is saved. This
should not happen because the node crashes the first time a call is placed after the
configuration is saved. (DRCaa21404)
This is fixed.
Vanguard 7300 Series - Call Not Transferred with ALT-Dest set in VST
When placing a call from either an FXS or FXO or E&M to H.323 and the
destination doesn't answer the phone (ALT_DEST_NO_ANSER) or the phone is
busy (ALT_DEST) and the alternate destination is either an FXS or FXO or E&M,
there is no audio. (DRCaa21589)
This is fixed.