Manualshelf

Installation manual

ManualsBrandsVanguard ManualsComputer equipment7300 Series
11121314151617181920
Part No. T0249-01, Rev A
April, 2002
Software Improvements Page 19 of 55
Software Improvements
Introduction This section describes specific improvements to the Applications Ware software. It
includes:
• Corrected limitations
• Customer-initiated Change Requests
Corrected
Limitations
Cache Clears on all Vanguard Products
A RIP version 2 update clears the routing cache. (INDaa01320)
This is fixed.
RIP Advertised Default Route Installed without Enable - All Vanguards
An Advertised RIP default route is installed in the IP route table and repeatedly ages
out with default G/W override disabled on the receiving IP interface. (DRFaa15504)
This is fixed.
Unknown ERROR Message on ISDN 5Ess Voice Call
The message "ISDN VOICE ERROR: me_ccs_voice.c Line # 5018" warns that the
A-Law/U-Law specification is missing in the SETUP message of Bearer Capability.
The call is processed according to the configured user information layer protocol for
the assigned virtual port. (DRCaa22153)
This is fixed.
Vanguard 7300, 6400 Series OSPF Routing Table Errors
When configuring entries in the OSPF Interface Configuration record, a limitation
might exist when:
• Routes are configured as point-to-point interfaces with HOST point-to-point
link representation.
• The routes appear as SPF routes in the OSPF Routing and IP Routing tables.
• When a point-to-point route is changed to NETWORK point-to-point link
representation and the OSPF menu is booted, the route appears as a DIRECT
routeandcanonlybeseenintheIPRoutingTable.
After a period of time, the route becomes an SPF route and appears in the OSPF
Routing IP Routing tables. This does not effect packet forwarding. (DRFaa11898)
This is fixed.
Vanguard 6520, 7300 Series H.323 - Coder Compatibility
A node crash might occur when a destination port is attempting to do a dynamic
coder switch to the compression rate configured in an H.323 port. (DRCaa20901)
This is fixed.
H.323 DEBUG Option - REPT_H323 - All Vanguard Products
The report generated when the H.323 REPT_H323 DEBUG option is enabled, does
not contain the port number. (DRCaa20819)
This is fixed.