Installation manual

2-80 Installation
Installing Software Options
Enabling A Software Access Key
Follow These
Steps...
Follow these steps to enter the number at the node's control terminal:
After you receive the printed version of the SAK, save a copy in a safe place in case
you have to enter it again.
Step Action Result/Description
1 Access the CTP. One way to do
this is to connect a terminal to a
local PAD port (Port 6), and enter
the following at the * prompt:
.ctp <CR>
You are prompted to enter the
password.
2 Enter the password. The default password is <CR>.
After you enter the password, the
Main menu appears.
3 From the Main menu, select
Configure.
4 Select Software Key Table.
5 At the *Key Value prompt, enter
the SAK.
If... Then...
You change the
SAK number or
enter the wrong
one by mistake
The option is
disabled.
You make a
mistake entering
the SAK
Blank out the
entry by
pressing the
space bar and
enter the SAK
number again.
6 Boot the node to implement the
option.
N
o
t
e
You need a separate SAK for each
node in which the option is to be
enabled.