Installation manual

2-76 Installation

Setting Node to Default Configuration

Introduction You can set a node to the default configuration in two ways:

• Set the DFLT switch on the front panel

• Select the Default Node selection from the CTP Main menu

Defaulting the

Node

Follow these steps to default the node using the DFLT switch:

Step Action

1 Push the DFLT switch to the left and press the RESET button.

2 Push the DFLT switch to the right when the STATUS light turns

steady on and press the RESET button.

3 Push the DFLT switch back to the left when the STATUS light turns

steady on and press the RESET button.

When the STATUS light turns steady on, the node is set to default

values.

For more information about the Default Node menu option, see the

Vanguard ONS Basics Protocols Manual