Installation manual

2-54 Installation

Replacing Processor Card Components

Introduction You can upgrade and replace components on the 6500

PLUS

processor card. In both

standalone and Modulus enclosures, you can:

• Replace DIMs (data interface modules)

• Set jumpers on the port interface pins

• Install single in-line memory modules (SIMMs)

• Replace a FLASH module

• Replace the ID Module

• Replace PROMs

• Replace the CMEM chip

Processor Card Figure 2-17 shows the location of these components on a 6500

PLUS

processor card.

Note

The PROMs are located beneath the FLASH Module.

Figure 2-17. 6500

PLUS

Processor Card

SIMMs DIMs Port Interface Jumpers

Trim

Card

U40

U83

CMEM Chip

ID Module

Port 1

Port 2

PROM

FLASH Module

(underneath FLASH Module)