Installation manual

Index-2
M
MAC address
updating 2-48
Modulus 18
grounding straps 2-50
Modulus enclosures 1-4
backplanes 1-5, 2-43
card replacement 2-35
description 1-5
installation 1-5, 2-19, 2-28
spacing for TRIM card 2-37, 2-40
types of 1-5
Multifunctional access server 1-6
N
Network Storage Option (NSO) card 1-13
NIS
not in service 2-69
O
Output signals
CL 2-69
CLK 2-69
IDL 2-69
LL 2-69
RS 2-69
P
Pinouts A-1
Port interface pins
jumpering 2-56
Power requirements B-2
Power-up
diagnostics 2-75
verification
failure 2-74
Processor cards 1-6
asynchronous access server 1-6
backup support 2-29
components
SIMM 2-59
installation
Modulus enclosure 2-35
standalone enclosure 2-22
multifunctional access server 1-6
TRIM card compatibility 2-36
R
RAM
installation 2-59
Replacing cards
Modulus enclosure 2-35
standalone enclosure 2-22
RFI grounding straps 2-50
RFI suppression bar 2-46
RS
reset 2-69
S
SAK 2-77
entering 2-80
ID Module 2-77
SIMM
installation 2-59
Single In-line Memory Module. See SIMM
Software Authorization Key. See SAK
Software options
installation 2-77
Software upgrade
from FLASH 2-33
Special notices
description ii
Specifications B-1
Standalone Enclosure 1-4
Standalone enclosure
installing 2-21
replacing cards 2-22
site selection 2-20
Starting up
Modulus node 2-53
Support cards
auxiliary processor 1-10
LAN TRIM card 1-15, 2-45
network storage option (NSO) card 1-3, 1-13
T
Temperature, operating B-2
Token Ring Interface Module card. See TRIM card
TRIM card 1-3
(figure) 1-14
cabling 2-46
installation 2-45
spacing in Modulus 8/18 enclosures 2-37
spacing in Modulus 9/21 enclosures 2-40
updating BIA 2-48
updating MAC address 2-48
Troubleshooting
power-up diagnostics 2-75