Specifications

Application Views Supported Applications
Device Management Page 80 Motorola Vanguard
NoOfDigitsToCol
Select number of digits to collect before making a
call.
NoOfRings
Number of rings to be received before a call can be
accepted. This parameter is displayed for FXO
and skipped for E&M and FXS interface types. A
value of 0 implies that this parameter was
skipped during configuration.
PCMMode
Select the PCM encoder/decoder mode. Valid
values are: aLaw and muLAW.
CompressionRate
Select the voice compression rate to be used by
the DSP. Valid values are: cD8K, c16k, cBD8K,
cB16k, cE8Kb, cE16Kb, and nc.
DSIControl
Select if the Digital Speech Interpolation (Silence
Detector) will be used with this channel. Valid
values are: enabled, disabled, and nc.
SmoothingDelay
Select maximum inter packet arrival jitter due to
network in milliseconds.
EchoControl
Select echo control. Valid values are: disabled,
enabled, and nc. This parameter will be skipped
in normal mode and only displayed when DEBUG
is turned on.
EchoReturnsLoss
Select echo return loss in dBm. Valid values are:
minus3, minus6, minus9, minus12, and nc.
TxInputSignalLe
Enter the input signal level. To be specified in
steps of 0.5 dBm.
Table 23: FXO Interface Type
Type Input Signal Level
600 Ohms +6.0 to -2.5dbm
600 Ohms
Adaptive
+6.0 to -2.5dbm
Table 24: FXS Interface Type]
Type Input Signal Level
600 Ohms +6.0 to -6.0dbm
Canada +6.0 to -5.5dbm
UK +4.5 to -7.5dbm
Germany +4.0 to -8.0dbm
France -2.0 to -9.0dbm
Belgium +4.0 to -8.0dbm