Specifications

Application Views Supported Applications
Device Management Page 79 Motorola Vanguard
signallingMode
Select the voice signalling mode. Table 21
displays the valid signalling modes:
signallingContro
Select signalling control transmission mode in
E&M interface type. Table 22 displays valid
signalling control modes:
This value will be nc for FXO & FXS type
interface.
Table 20: HybridEAndM2 Filters
Filter Description
sixHundred 600 ohm interface for USA, Japan and
Ireland.
Germany 220 ohms in series with (820 ohms in
parallel with 115nF).
UK 370 ohms in series with (620 ohms in
parallel with 310nF).
nc Skipped during configuration.
Table 21: Signalling Mode
signalling Mode Description
normal Allows signalling to pass end to end
and signalling will be used to control
circuit state and packet flow.
node A permanent voice path is established
and packet flow is always enabled, but
no signalling will be passed through.
nc Skipped during configuration.
Table 22: Signalling Control Transmission
Mode Description
immediate Digits are transmitted immediately.
wink Digits are transmitted after the
WINK pulse.
transparent The voice signalling states are
transmitted end to end without
interpreting the signalling state.
delay Digits are transmitted after the end
of the Delay Dial signal.
masterColisee 65xx is simulating Colisee master
mode.
slaveColisee 65xx is simulating Colisee slave
mode.
seizureAcknowledge Transmit Seizure acknowledge
immediately after receiving a
Seizure signal from the PBX.
nc Skipped during configuration.