Specifications

Application Views Supported Applications
Device Management Page 35 Motorola Vanguard
passing. Valid values are: disabled, enabled, nc
and newvalDisabled (same as disabled).
ConnTime
The amount of time in seconds the circuit will
remain connected without passing any data
before being brought down. Setting this
parameter to zero keeps the circuit up
indefinitely.
Conntype
Specifies whether the LAN Connection defines a
point to point connection across the WAN, or is
part of a group of LAN Connections. Valid options
are: ptToPt, group, nc, and newvalPtToPt (same
functionality as ptToPt).
NextHopIp
The IP address of the Router Interface on the
other end of this LAN Connection, which is the
next hop on the path to the final destination. A
setting of 0.0.0.0 causes this parameter to be
ignored.
NextHopIpx
The IPX node number of the Router on the other
end of this LAN Connection, which is the next hop
on the path to the final destination. A setting of 0
causes this parameter to be ignored.
MaxSVC
The maximum number of parallel connections
that can be established to the remote destination.
Parallel SVCs are established when congestion
thresholds are reached on active connections.
Threshold
The number of outstanding data bytes that will
trigger the establishment of a Parallel SVC. If this
number of data bytes has been transmitted
without acknowledgment, the receipt of additional
data for transmission will trigger Parallel SVC
establishment. Note that this parameter must be
configured with a value less than the LCON
Queue Limit parameter.
ParallelPort
The port that Parallel SVCs should be brought up
over. The parameter can be in two forms. It can be
in the form of a port identifier string. It can also
be in the form of a Switched Services Table
destination name, if the port that the Parallel
SVCs are to come up over is a dial on demand
port. A value of (blank) will cause Parallel SVCs to
be brought up over the same port as the main
connection.
BroadCast
This parameter specifies whether broadcast
datagrams should be transmitted over this LAN
connection to the remote destination. Valid values