Specifications

Application Views Supported Applications
Device Management Page 100 Motorola Vanguard
are listed in the following table. Table 37 lists the
port option codes and descriptions:
Table 37: X.25 Port Option Codes
Code Description
NONE No option specified.
1980 Use X.25 1980.
NUI Perform network user ID validation check.
PDN Connected to Public Data Network.
CUD Use call user data sub-addressing.
IBAR Bar all calls coming in from X.25 port user.
OBAR Bar all calls going out to X.25 port user.
CBCK Allow routing inbound calls back out this
port.
CUG Check closed user group; otherwise, CUG
passes transparently.
CAUSE Pass cause, diagnostic, code in outbound
packets.
DEDO Delete called address from outbound calls.
DEGO Delete calling address from outbound calls.
REGI Replace calling address with configured Port
Address in inbound calls.
REGO Replace calling address with configured Port
Address in outbound calls.
HOLD Hold calls over link restart.
NRST Do not send restart packet on link-up.
BKUP This is a backup port to be activated if other
ports are down.
SRGI Select route by the calling address in
inbound calls.
INL Inter-node link. Link goes to another 6500
device.
INLA Set with INL option when an X.25 link con-
nection is to a 6500 node using 2.12.04 or
earlier.
DADA Delete called address in inbound/outbound
call accept packets.
DAGA Delete calling address in inbound/outbound
call accept packets.
IADD Include called and calling addresses in call
accepted/connected packet.
DELAY Enable Delay and Path trace on this link
(link must connected to Rel. 4.xx node).
Table 37: X.25 Port Option Codes
Code Description