Technical information

Part No. T0289, Rev A
August, 2008
Release 7.1 Preliminary Technical Information Page 93 of 97
IPFLOW IPFLOW now supports MLPPP and T3/E3 ATM Links (7300).
This was accomplished by changing the way that meters are configured.
Meters are now configured by referencing an LCON only.
Here is an example of the configurable parameter for IPFLOW meters:
DHCP Server DHCP Server Enhancments
*NOTE
: If upgrading from previous releases supporting IPFLOW then
meter entries must be re-entered and saved before operation.
Meter Type
Range None, Ethernet, LCON
Default None
Description This parameter specifies the meter type for this record
entry.
None - No outbound meter.
Ethernet - Outbound metering is performed on an
ethernet port.
LCON - Outbound metering is performed on an
LCON. Use LCON for a Frame Relay link
or an MLPPP link.
Boot Type
Note:
Originally released in Patch
7.0T16A
1.) Number of subnets supported in the DHCP Server has been
increased to 64 from 16.
2.) Number of DHCP clients supported per subnet has been increased
to 254 from 128.
3.) The ability to set an exclude range. This allows for more flexibility of
configuring excluded IP addresses across the client pool of available
addresses.