Technical information

Part No. T0289, Rev A
August, 2008
Software Improvements Page 14 of 97
Software Improvements
Introduction This section describes specific improvements to the Applications Ware software. It
includes:
Customer-initiated Change Requests
New features to address new applications
Release 7.1.R00A
Customer Initiated
Change Requests
These Change Requests were reported to Customer Service and interim patch
releases were released to fix the problems. These Change Requests are incorporated
into Release 7.1.R00A, and where applicable, interim patch releases have been
replaced by Release 7.1.R00A:
Change
Request
(CR#)
Interim Patch
Release
Replaced by
Release 7.1.R00A
Problem Description
16792 6.5.T29C Multiple Dynamic IPSEC Tunnels will not re-establish after outage.
16801 6.5.T23D QOS allocating bandwidth Improperly.
16803 6.5.T29C Node crash when booting a dynamic tunnel that is down.
16815 6.5.T30B Cannot configure Service profile >100 in the QCL menu.
16843 6.5.P20K Customer cannot transfer calls.
16853 6.5.P20K Customer is not hearing call back tone.
16859 N/A BRI voice ports not booting up, node resets due to out of memory.
16866 6.5.T24C When calling busy number, calls disconnects without giving any busy
tone.
16889 6.5.P30D BGP routes not passing, policy look-up table not working.
16906 6.5.P20M PBX services Transfer function not working with SIP.
16978 7.0.S100 BSC2780-LLC stats are incorrect once you get to 100 devices.
17002 7.0.T10A Ethernet Port indicates a Port Up status without a cable.
17012 7.0.T16E With Encryption and Segmentation enabled, packets larger than 1100
are dropped.
17014/
17401
7.0.S100 DHCP Server not working properly.
17026 7.0.T16E Encyption not recovering from SPI errors w IPSEC Tunnels when run-
ning MD5.
17038 7.0.T16B Can not disable IP Source Routing.
17046 N/A VG S/W Builder requires Security License to allow you to select SSH.
It should be included in the base license.