Installation manual

Part No. T0001-43, Rev B
February, 2003
MIB Downloading Instructions for Non-Vanguard Managed Solutions SNMP Managers Page 89 of 99
Required Files and
Loading
The following MIB files are required by your NMS to perform SNMP management
of Vanguard products:
• rfc1213.mib
• cdx_6500.mib
These files must be loaded first and in the order shown.
After you load these required files onto your NMS, you can load the MIB files for
the options and protocols installed on your Vanguard hardware. See the MIB Files
for Options/Protocols section below.
MIB Files for
Options/Protocols
This table lists the contents of options and protocol MIB files for Vanguard products.
Use this table to determine which MIB files you need to download.
Download
This MIB
File
If you want this option, protocol, or base MIB software
alc.mib ALC protocol
bcst.mib Broadcast
bri.mib ISDN BRI protocol
bridge.mib Bridging option
bsc2780.mib BSC2780 protocol
bsc3270.mib BSC3270 protocol
bstd.mib Burroughs Poll/Select protocol
cdx_6500.mib Required base MIB for Vanguard Products MIBs
de.mib Data Encryption option
dc.mib Data Compression option
dcp.mib Data Connection Protection option
dsd.mib Digital Sharing Device Option
e1.mib Physical E1 port
eia.mib EIA protocol (required file for serial protocol support)
eth.mib Ethernet option
frdce.mib Frame Relay DCE option
frdte.mib Frame Relay DTE option
fri.mib Frame Relay option
gcs.mib GSC protocol
hub.mib Ethernet Hub option
ibm2260.mib IBM2260 protocol