Installation manual

Part No. T0001-43, Rev B
February, 2003
Known Software Limitations Page 51 of 99
Vanguard 7300 NAT Node Reset
If a large number of NAT entries are configured each having multiple interfaces,
upon a Boot-Router-NAT-ALL the router could reset (with an FER) instead of just
booting the NAT entries. (DRFaa20065)
Workaround: In order to avoid having the router reset, only configure a single
interface per NAT entry. If an entry requires to be applied to multiple interfaces, you
may configure multiple entries, but depending on the number of entries the node may
reset upon boot.
SNABSC Requires a Second Boot
SNABSC Requires two LU boots when adding a record. (DRFaa21434)
Workaround: To add a new SNABSC device configuration and activate it:
1) Go to Main-Configure-SNA Features Configure-SNA to BSC Conversion Device
Table. Configure a new device in a blank entry in "SNA to BSC Conversion Device
Configuration."
2) Go to Main-Boot-SNA Features Records Boot-SNA to BSC Conversion Device.
Do the boot of the new entry in "Boot SNA to BSC Conversion Device Records"
TWICE.
3) At this point, the SNA Host must activate the LU assigned to the new device to
start the new session.
Vanguard 7300 MAC Address Filter Table Displays an Extra Hyphen
The MAC Addresses displayed in the MAC Address filter table are not displaying
correctly. (DRCaa23181)
Workaround: Ignore the extra hyphen.
Node Crash May Occur When Running RADIUS Voice Accounting
and H.323 Voice Calls
The RADIUS voice accounting data forwarding function should not be used together
with H.323 voice calls, it may cause a node crash (DRCaa23452).
When running H.323 voice call together with RADIUS, the forwarding of voice
accounting data to the RADIUS server should be disabled. Follow the procedure
described below: (Accounting data is available through SNMP MIB query.)
Main Menu->Configuration->Configure RADIUS->Configure RADIUS Client
Entry Number: 1/
[1] Radius Application: Default/
[1] Enable Radius Client: Disabled/enable
[1] Authentication Method: Remote-then-Local/
[1] Username/Password Buffer Number: 0/;
Storing updated record in configuration memory
Entry Number: 2/
[2] Radius Application: Default/Voice-Accounting
[2] Enable Radius Client: Disabled/;