Installation manual

Part No. T0001-43, Rev B
February, 2003
Software Improvements Page 41 of 99
11881 DRFaa21196 6.2.iR00U 6.1.T12A Vanguard 7300 cannot run
Channelized T1 data using
56K channels with B8ZS and
ESF.
11886 DRFaa21236 6.1.T02B 6.1.T02C Vanguard 7300 conditional
default route is not being
advertised until node boot.
11887 DRFaa21240 6.1.S100 6.1.T13A Vanguard 7300
ATM FRST
X.25 profiles does not support
Extended Frame and Packet
Sequence Counting.
11890 DRFaa21255 6.1.R000 N/A Vanguard 6400 MIB tables not
indexed correctly.
11891 DRFaa21244 6.1.R000 6.1.T14A Vanguard 7300
Revision K
System Processor cards reset
before getting to the OK
prompt.
11894 DRFaa21278 6.1.T02B 6.1.T02C Vanguard 7300 PPP single T1
port and 4 T1 MLPPP bundle
produce errors on every RIP
update.
11896 DRFaa21270 6.1.R000 6.1.T13A Vanguard 7300ATM FRST X.25
profile does not support Window
Subtractor.
11898 DRFaa21287 5.6.R000 6.0.T1YA Vanguard 6400
when telco
ISDN cables are connected to
BRI CD, statistics show layer
one state is loop test.
11903 DRFaa21300 6.0.R00A 6.1.T13A Vanguard 7300 AAM Station
Down is a medium alarm and
it should be a high alarm.
11904 DRFaa21302 5.6.S200 N/A Vanguard 6400 cannot use the
IP address of the outbound
Interface as the source IP
address.
11907 DRFaa21331 6.1.S100 6.1.T13A Vanguard 7300 ATM alarm
does not indicate which ATM
station the error occurred on.
Change
Request
(CR#)
Limitation
Number
Release Where
Problem Was
Reported
Interim Patch
Release
Replaced by
Release 6.2
Problem Description