Installation manual

Part No. T0001-43, Rev B
February, 2003
Software Improvements Page 35 of 99
Vanguard 340, Vanguard 6400 Series - G.711 Coder Types Do Not
Appear Under Voice Port Statistics
Voice port statistics do not show that G.711 coders are available in the build.
(DRCaa23042)
This is fixed.
Time Slot Number is always One on the First Page of the Statistics -
Vanguard 6400 Series
When there are multiple voice calls connected with the same T1/E1 interface, the
"Time Slot" value on the first page of the Virtual Port Statistics always shows the
time slot number of the first virtual port associated with that T1/E1 interface.
(DRCaa22116)
This is fixed.
Vanguard 6560 QLLC State
QLLC state remains at LINK_OPENED after the DCP reconnection timeout.
(DRCaa22766)
This is fixed.
Improper Default Bridge Link/Router Interface Numbers for LAN Ports
Vanguard 7300 Series
All LAN ports receive the same default bridge link (1) and router interface number
(1) when the node is defaulted. (DRCaa21838)
This is fixed.
NS Strings with Port Number for Primary Ethernet card does not work
With dual Ethernet cards, Vanguard 6520, 6560 and 6400 Ethernet cards are unable
to handle Network Services Table's Port/Station Identifier if the Primary Ethernet
card's strings have port number after LSC-ETH
. The strings entered into the
Network Services Entry for LLC to SDLC Stations on the first Ethernet ports are
limited to: LSC-ETH1, LSC-ETH2,...LSC-ETH250, or LSC-ETH*. (DRFaa15760)
This is fixed.
Ethernet PMC Installed - Ethernet Port Null - Vanguard 7300 Series
The Ethernet port 101 does not work if you load a CMEM that was created on a node
that did not have an Ethernet PMC installed, into a node that does. If you attempt to
look at the port’s statistics the node states that it does not exist. Attempting a port
boot indicates it is a NULL port (DRCaa22566)
This is fixed.
All Vanguards - Directory Limitation when Creating Images
Vanguide Application Builder and Service Patches can only be installed under a
directory that is no more than eight characters (DOS 8.3 format), since Vanguide
Builder calls a third party image LINKER which only supports the directory/file
name in DOS 8.3 format. (DRFaa19749)
This is fixed.