Installation manual

Part No. T0001-43, Rev B
February, 2003
Boot Prom Software Updates Page 26 of 99
5) Download the appropriate coldloader to your PC for the correct Bootprom
version, from the following directory example:
C:\Vanguard\SFW_IMGS\73*0\COLDLOAD\T10BP1**
Note
You must use the coldloader from the current bank column of the table
in step 4 to load the Bootproms.
6) When using the Procomm application:
• Select Send File from the Procomm Data Menu
• Select RAW ASCII transfer mode
• Select 9600 for the Coldloader speed
The following figures show the Procomm application.
Note
To be sure you are in RAW ASCII transfer mode, when in Procomm, check the
setup file. Options->Data Options
Figure 4. Procomm Plus Terminal
RAW ASCII