Installation manual

Part No. T0001-43, Rev B
February, 2003
Vanguard Feature Comparison Chart Page 20 of 99
Software Configuration Limits
Introduction This section describes the software configuration limits.
Configuration
Limits
This table lists the software configuration limits for:
• Physical Ports (physical port counts are set by software,
not the actual number of physical ports)
• Frame Relay
• Sessions
• Network Services
• LAN - (IP specific)
•Voice
• SNA/IBM Support
Software Configuration 7300 Series 6435/55
Physical Port Maximum Limits
Physical ports 88 20
Ethernet ports per node (performance limited at 100MB speed per port)
5
Total LAN ports (Ethernet) per node (not bridge port support count) 5
Devices supported per Ethernet segment (Relevant to Bridge
operation)
255 255
High speed (V.35) serial links per node 56
PRI ports (data only) per node 84 2
T1/E1/PRI voice only ports per node 14 2
T3/E3 ATM ports per node 2 0
Voice circuits per voice server card 60 60
Number voice calls per node (Number shown is E1 max.) 420 60
Number voice calls per node (Number shown is T1 max.) 336 60
Frame Relay
Number of DLCIs per FR Port 820 254
Number of PVCs per FR Annex-G station 128 128
Number of SVCs per FR Annex-G station 512 512
Number of Voice SVC per Annex-G station 15 15
Number of DLCIs per node 8,000 1,024
Session
Number of LCON 2,000 2,000
Number of Virtual Ports (FR, X25, PPP, Voice) 2,000 155
Number of multi-link PPP profiles
(7300 Series original size was 600)
1,00060