Installation manual

Part No. T0001-43, Rev B
February, 2003
Vanguard Feature Comparison Chart Page 19 of 99
CLI
(Command Line
Interface)
The following new commands are
supported:
> getdefault
> getdefaultall
> getnondefault
> getnondefaultall
> update
CLI instance value:
Support HEX instance value
Supporting port number:
Up to 255 port number
The following new commands are
supported:
> getdefault
> getdefaultall
> getnondefault
> getnondefaultall
> update
CLI instance value:
Support HEX instance value
Supporting port number:
Up to 255 port number
Commands supported only in
7300:
> flash copyimage
> flash copycmem
> flash activeimage
> flash activecmem
> flash deleteimage
CLI instance value:
Support only INTEGER instance
value
Supporting port number:
Up to 65536 bit port number
SNMP The following MIB objects are
supported only in 6560/5.5 platform.
cdx6500T1E1VGTable
cdx6500TdmClkTable
The following MIB objects are
supported only in 6560/5.5
platform.
cdx6500T1E1VGTable
cdx6500TdmClkTable
The following MIB objects are
supported only in 7300 platform.
cdx6500PSTT1E1TGPortTable
cdx6500PSTT1E1TGTable
cdx6500STTdmtgClkGroup
1) All signalling types/variant combinations support user or Network side and T1 or E1.
2) Q.Sig/Euro ISDN support on T1 interfaces is now available in Release 5.5, 5.6, 6.0.R00A, 6.1.R000 and 6.2.R000
3) NTT Signalling support is currently unavailable and is targeted to be added in a future release.
4) Transparent CCS can be supported manually by means of configuring the TBOP data channel for “Signalling” channel and Voice Bearer
channels with None for signalling. Virtual port mapping table entries for voice ports must be TDM-VOICE.
5) Q.Sig Support now includes Basic Call, Supplementary Services and Segmentation.
6) Enblock Signalling Support only at this time.
Feature Vanguard 6560 Vanguard 6450/6455 Vanguard 7300