Installation manual

Part No. T0001-43, Rev B
February, 2003
New Features Page 14 of 99
Verification Verification can be done by checking the Chassis Version printed at the top right of
page one of the Detailed Node Statistics.
Figure 1. Page 1 of the Detailed Node Statistics
Configuration If a Vanguard 7300 Series Version 1 is set to Version 2 and needs to be configured,
use the ZAP menu to set it to Version 1. This is required for the node to work
properly. Follow the steps below to set the correct version.
Node: 7310_1 Address: 100 Date: 13-AUG-2002 Time:15:53:07
Detailed Node Statistics Page: 1 of 11
Product Type: VANGUARD 7310 Chassis Version: 2
Bootprom Revision: V1.50
Configuring and Setting the Version
Step Procedure
1 Load 6.1.R000 or greater on the Vanguard 7300 Series.
2 Reset the node, either by a software cold boot (CTP menu item 7.5) or by
pressing the reset button on the CPU card. When the hardware
diagnostics program starts executing, type ZAP (upper or lower case).
Figure 2 shows the menu that will appear.
3 Change the Chassis version.
4 Reboot.
Note
Once the Chassis Version is set, it is maintained regardless of the
clearing or loading of CMEM. The only way this pararmeter could be
lost is if the FLASH is reformatted.