Installation manual

Part No. T0001-43, Rev B
February, 2003
New Features Page 13 of 99
Vanguard 7300 Series Routers - Version 1 and Version 2
Release 6.1 Vanguard 7300 Chassis Redesign (Version 2)
The Vanguard 7300 Series chassis has been redesigned. The redesigned chassis is
referred to as The Vanguard 7300 Series Version 2. Software must be configured to
match the chassis type and version. (DRFaa20456)
7300 Version 1
Enclosure Features
The table below summarizes common and distinct features of each Vanguard
Version 1 Series enclosure:
7300 Version 2
Enclosure Features
The table below summarizes common and distinct features of each Vanguard
Version 2 Series enclosure:
Set the Chassis
Version Settings
When upgrading a 7300 Series Version 1 to release 6.1.R000 or greater, you must set
the chassis version setting. If the setting is incorrect (for example, upgrading a
Version 1 7310 to 6.1 or greater software) the interface cards will not be recognized
by the node in the correct physical slot location. Incorrect settings can be fixed by
setting the software Chassis Version through the ZAP diagnostics menu.
Note
Units shipping from the factory with Release 6.1.R000 or greater will have the
version set to match the chassis. Release 6.1.R000 or greater software is required
for Vanguard 7310 and 7330 Version 2.
Feature Vanguard 7310
Version 1
Vanguard 7330
Version 1
Number of Slots 5 (horizontal) 8 (vertical)
Height 3U 8U
Rack-mountable Yes Yes
Redundant AC and DC Power none Yes, dual power
supplies
Feature Vanguard 7310
Version 2
Vanguard 7330
Version 2
Number of Slots 5 (horizontal) 8 (horizontal)
Height 4U 4U
Rack-mountable Yes Yes
Redundant AC and DC Power Yes, dual power supplies Yes, dual power
supplies